Perancangan Sistem Audio Crossover Berbasis Digital Filter Menggunakan STM32L4
DOI:
https://doi.org/10.33795/jartel.v9i4.141Keywords:
Audio Crossover, FIR, Windowing Rectangular, STM32L4, Digital Signal ProcessingAbstract
Analog telecommunication system equipment is now starting to develop and be replaced with digital telecommunication systems, one of them is in the audio signal processing. The focus of audio processing is audio crossover. Audio crossover in development there are still many who use analog systems. This analog system has disadvantages when adjusting the sound balance because it still uses analog filters to balance it. It is necessary to develop a technology that aims to create a digital-based crossover audio system using the STM32L4, so that by using this digital-based signal processing it is able to adjust the sound more specifically than the signal processing used analog based. This digital filter uses the Finite Impulse Response (FIR) method. Testing audio crossover using STM32L4 produces a digital-based crossover audio system design using a STM32L4 microcontroller with a voltage of 3.3V as power supply, mp3 player as sound input device, FIR filter as digital filter processing, LM386 as sound amplifier and speaker as sound output for crossover audio on range
low frequency (200Hz to 4000Hz), high (2200Hz to 6000Hz), medium (200Hz to 4000Hz).
References
Yudhistira, Kurniawan, “Rancang Bangun Digital Eqqualizer Berbasis Mikrokontroler ATMega 8535”, Jurusan Teknik Komputer, Politeknik Negeri Sriwijaya.
Addina, Adella A.V , “Implementasi Filter Finite Impulse Respone (FIR) Pada DSK TMS320C6713 Transceiver Menggunakan Teknik Windowing”, Progam Studi Jaringan Telekomunikasi Digital, Jurusan Teknik Elektro, Politeknik Negeri Malang, 2018. (Diakses tanggal 10 Februari 2019)
Putra, Rizki Jumadil,, “Implementasi Filter Digital FIR (Finite Impulse Response) Pada Field Progammable Gate Arrays (FPGA), Teknik Elektro, Universitas Brawijaya, 2013.
Jacko, Patrick, “The Parallel Data Processing Bay Nucleo Board with STM32 Microcontroller”, Department of Theoretical and Industrial Electrical Engineering, Košice, Slovakia
Korhola, Henri, “Perceptual Study of Loudspeaker Crossover Filters”, Faculty of Electronics, Communications and Automation, Helsinki University Of Technology.
A. Rimell and M. O. Hawksford, “Digital crossover design strategy for Drive Units with impaired and non-coincident Polar characteristic”, The 95th Convention of the Audio Engineering Society
Budi, Tri Santoso, “Design Finite Impulse Response Filter”, Group Sinyal, EEPIS-ITS
STMicroelectronics, “STM32KC”, https://www.st.com/en/microcontrollersmicroprocessors/stm32l432kc.html>, Maret,2019
STMicroelectronics, “STM32 Nuckelo kit for STM32L432KC Line”, STM32 Nucelo datasheet, Mei, 2018
ARM KEIL Microcontroler Tools, “Microcontroller Development Kit”, http://www2.keil.com/brochures/>, 2015
Arm Development, “GNU Arm Embedded Toolchain”, https://developer.arm.com/tools-and-software/open-source-software/developer-tools/gnu-toolchain/gnu-rm>, 2017
STMicroelectronics, “STM32CubeMX for STM32 configuration and initialization C code generation”, STM32 Nucleo datasheet, April, 2019
Jervis, Peter, “LM386 Audio Amplifier Module”, Electronics Kit, https://www.petervis.com/Electronics_Kits/lm386-audio-amplifier-module/lm386-audio-amplifier-module.html>. 2018
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2019 Mohammad Dicky Nasrulloh
This work is licensed under a Creative Commons Attribution 4.0 International License.
